Modular slot drains isolated with inner width 100mm. with double flange type ITMP



ITMP KAG KYG 400 multi
ITMP LAG LYG 400 multi
ITMP OAG OYG 400 multi

Spout on one side descending on spout.
Drainage pit with odor trap.

Spout descending from an angle at the spout.
Drainage pit with odor trap.
Center drain descending to the spout.
Drainage pit with odor trap.
ITMP 3AG 3YG 400 multi
SPK KA3G 9 KY3G 9 400 multi
T-shaped drains
center drain - descending to the drain.
Drainage pit with odor trap.
MODEL:ITMP -MULTITwo or more drains
with odor lock each from point
descend to the drain.




- With a channel with a minimum depth of 105 mm and a maximum depth of 200 mm, it is possible to build a continuous waste water drainage system with a maximum length of 18000 mm, with a constant slope of 0.6% towards the drain.
- The trenches can be made to the desired dimensions, provided that they meet the slope, minimum and maximum depth.
- By reducing the slope of the gutter, it is possible to construct a trench up to a maximum length of 70.00 meters.
- By using several floor drains, it is possible to construct a trench of several meters.
- The slot channel is provided on both sides with adjustable feet and anchorage strips with a mutual distance of 500 mm. This allows the trench to be attached to a concrete surface and adjusted in height.
- The drains with a plate thickness of 2.00 mm is provided with a flange of 35.00 mm. This is provided with a gasket and is attached with bolt and nut. The bolt and nut are made of 18/8 Cr / NI (AISI 304 quality).

- On request, this drain system can be made of stainless steel AISI 316 quality.
- A PVC or stainless steel filler profile can be used to simplify assembly and to strengthen the load-bearing capacity of the upper profile.






Stainless steel products